

Good recommendations, it’s almost the same list of upgrades that I’ve done to my E3v2. I went with a dual Z-screw upgrade which uses a sync belt instead of a second motor, since I use the stock board and didn’t want to run two steppers off the same driver (it should work IIRC, but it seemed annoying if they get out of sync since the printer can’t level them individually)
Also never use that damn scraper everyone I know who has including myself has a scar from it lol
I use it all the time if a model won’t come off easily. I grab the blade between two fingers, and then hammer the model from the side with the handle to knock it off the plate :)
You do NOT need an all metal hotend with this, use the stock red one it’s all you need
Technically the hotend becomes “all metal” with this, as the PTFE-tube does not go all the way down to the nozzle after the upgrade. Best illustration I could find
Hehe, PETG and glass is a notorious combination, I only printed it a few times but I put covered the bed with blue painter’s tape just to be on the safe side. I’ve never really had any adhesion problems after starting to use Magigoo (which I also never wash off, I just add another layer every few months) but occasionally I get a bit impatient waiting for the bed to cool down.