• roofuskit@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    5 days ago

    Old Ender 3s and the like work just fine with PETG. Not sure where you got the impression they don’t.

    There’s nothing special about printing PETG that requires a big change over PLA. Printers have been hitting those temps since the rep rap days.

    • finitebanjo@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      5 days ago

      Personal experiences with a cheap sovol that turned itself off when the temperatures went up during a long print.

      • papalonian@lemmy.world
        link
        fedilink
        English
        arrow-up
        0
        ·
        edit-2
        4 days ago

        It sounds like it may have been reaching a thermal shutoff point and killing itself. Maybe the temp you were aiming for was close to the limit, and slight variations caused it to go over and “save” itself.

        The only thing that might keep a printer that prints PLA well from printing PETG well is if it’s an old printer without a heated bed. Save for that (and potentially faulty hardware or miscalibrated settings), there’s not really anything that “can’t” print PETG.

        I actually have some PLA+ rolls that print at higher speeds temps than my PETG rolls 🤷🏾‍♂️

        • finitebanjo@lemmy.world
          link
          fedilink
          English
          arrow-up
          0
          arrow-down
          1
          ·
          edit-2
          5 days ago

          I’m sorry but that’s incorrect. All of that. Your guesses were wrong. Except it is absolutely a sensor telling the machine to turn off, that part is right.

          • papalonian@lemmy.world
            link
            fedilink
            English
            arrow-up
            0
            ·
            edit-2
            5 days ago

            You seem incredibly confident in your diagnosis for someone who can’t get a very common filament to work on printers that have been using it for years. Care to elaborate more than, “you’re completely wrong, except for where you’re right”? What was causing the problem?

              • papalonian@lemmy.world
                link
                fedilink
                English
                arrow-up
                1
                ·
                edit-2
                5 days ago

                It is, but you’re being incredibly hostile (and vaguely xenophobic) towards someone who was literally just trying to chat about an issue you were having with a product you purchased and were disappointed in.

                I’m still curious as to what you determined the problem to be with your printer, but I’m assuming you never figured it out, threw it in a closet, and now bitch in 3d printing communities about how bad their hobby is.